11 12 040 Removing and installing all ignition coils and injector wells (N20, N26)

Necessary preliminary tasks: 

• Remove CYLINDER HEAD COVER .
• Remove all INJECTORS .

Release screws (1).

Tightening torque: 11 12 6AZ .

Remove injector slot (2).

Fig 1: Identifying Screws And Injector Slot

Courtesy of BMW OF NORTH AMERICA, INC.

Check fitting bushes (1) for damage.

Installation note: 

Replace gasket (2).

Fig 2: Identifying Bushes And Gasket

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.