51 23 211 Removing and installing/replacing pull cable for hood/bonnet locks at front

Necessary preliminary tasks: 

• Remove the engine compartment lid catch on the left and right  . See 51 23 110 REMOVING AND INSTALLING/REPLACING LEFT ENGINE COMPARTMENT LID LOCK  or 51 23 100 REMOVING AND INSTALLING/REPLACING RIGHT ENGINE COMPARTMENT LID LOCK 

Unclip clutch housing Bowden cable (1) at marked points.

Installation note: 

Clips must not be damaged.

To open up clutch housing cover, lever up cover (2) in direction of arrow.

Fig 1: Removing Clutch Housing Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Feed rear Bowden cable (2) out of holder (1) and clutch housing (3).

Fig 2: Identifying Bowden Cable, Holder And Clutch Housing

Courtesy of BMW OF NORTH AMERICA, INC.