51 43 201 Removing and installing or replacing trim for roof pillar at front (A-pillar), left or right

Special tools required:

WARNING: Follow SAFETY INSTRUCTIONS for working on vehicles with airbag systems (risk of injury).

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Unclip and remove sealing cap (1) using special tool 00 9 340 .

Fig 1: Removing Sealing Cap Using Special Tool (00 9 340)

Courtesy of BMW OF NORTH AMERICA, INC.

Detach edge protector (1) in area of trim (2).

Release bolt (3).

Tightening torque 51 43 1AZ .

Unclip panel (2) at fastening points (4).

Feed out panel (2) from instrument panel (5) and remove.

Fig 2: Detaching Edge Protector

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, lever out clips (1) remaining in bore.

If necessary, replace faulty clips (1).

Make sure guides (3) of panel (2) are correctly seated in associated mountings.

Position panel (2) pre-installed with clips (1) on associated bores and clip into place.

Fig 3: Identifying Panel, Clips And Guides

Courtesy of BMW OF NORTH AMERICA, INC.