51 16 060 Removing and installing/replacing inside mirror (with high-beam assistant)
If this can not be guaranteed (cold/hot countries), it is necessary to equalize the temperature of the windscreen, mirror base and inside mirror (e.g. vehicle left to stand indoors or in the shade for at least 30 minutes).
Equipment specification with remote control for central locking:
If necessary, disconnect ground cable from BATTERY .
Twist off interior mirror from mirror mount.
Inside mirror must not be pulled or pressed off towards front or rear.
Press on end caps (1) and at same time pull them apart; this releases clip connection of both caps (1).
Twist inside mirror (2) and detach end caps (1) from inside mirror and feed out.
Installation note:
Retaining hooks (1 and 2) of end caps (3) must not be damaged.
Disconnect plug connections (1 and 2).
Installation note:
If necessary, pay attention to cable routing for rain sensor.
Twist mirror base approx. 45° to right until mirror base is released from mirror base.
Installation note:
- Twist mirror base by approx. 45° and fit to mirror mount.
- Turn mirror base until it can be felt to engage on mirror mount.
- Visually inspect for positive locking.
High-Beam Assistant is automatically aligned under the following conditions:
- Driving on a highway/ordinary road at night for approx. 50 km and
- Clearly visible road markings
Replacement:
Carry out PROGRAMMING/ENCODING .
Only replace with equipment specification with remote control for central locking:
If necessary, initialize all transmitters (ignition keys).
For vehicles with a blue connector (1) and installation of inside mirror with new version, the mechanical coding (2) must be removed.