13 71 030 Removing and installing/replacing both intake silencer housings (N63)
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2017 BMW M6, 2017 BMW 650i xDrive, 2017 BMW 650i, 2017 BMW 640i xDrive, and 2017 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Switch off ignition.
- Remove ACOUSTIC COVER
NOTE:
Description for intake silencer housing. Procedure for the right side is identical.
Release clamps (1).
Tightening torque 13 62 9AZ .
Unfasten connector (2) on hot film air mass meter and disconnect.
Release clamp (3).
Unclip the oxygen sensor cable from the intake filter housing.
Detach intake air filter housing from intake port, pull off upwards and remove.