17 11 035 Removing and installing/replacing fan cowl with electric fan (N63)

Necessary preliminary tasks

Read out fault memory of DME control unit.
Turn off ignition.
Remove CROSS-MEMBER .
Remove intake ducts on left and right. See 13...... REMOVING INTAKE DUCT (N63) .
Remove front UNDERBODY PROTECTION .

Detach coolant hose from fan cowl at retainer (1).

Fig 1: Identifying Coolant Hose Retainer

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect plug (1) on fan cowl.

Release screw (2) on holder for coolant hoses.

Tightening torque 17 10 5AZ .

Detach coolant hoses with holder from fan cowl.

Fig 2: Disconnecting Coolant Hoses From Fan Cowl

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque 17 10 3AZ .

Detach transmission oil cooler upwards from fan cowl.

Fig 3: Identifying Transmission Oil Cooler Retainer And Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip fan cowl (1) at retainers (2) on left and right, feed out in upward direction and remove.

Fig 4: Removing Fan Cowl

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert retaining tab (1) at bottom on module carrier.

Fig 5: Identifying Retaining Tab

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault message.
Reassemble the vehicle.
Clear fault memory.