65 11 075 Removing and installing/replacing DVD changer

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

IMPORTANT: Comply with instructions on HANDLING OPTICAL FIBRES .

Necessary preliminary tasks:

NOTE: Affects all vehicles from series introduction to 09/2009 with DVD changer (SA696)!

When a new DVD changer (2) is being replaced (as of 09/09 ), conversion to ISTA/P must be carried out.

If the old DVD changer (1) is installed (up to 09/09 ), this conversion to ISTA/P must not be carried out.

The old DVD changer (1) and the DVD changer (2) have an external difference in that the Load and Eject buttons are swapped round.

Fig 1: Identifying DVD Changer

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip trims (1) with a suitable tool and release screws behind.

Pull DVD changer (2) out of guide.

Unlock associated plug connection (3) and disconnect.

Remove DVD changer (2).

Fig 2: Identifying Trims, DVD Changer And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: