64 12 160 Removing and installing or replacing complete independent heater with bracket

WARNING:

Risk of burning!

Only perform the following repair work on an engine that has cooled down.

NOTE: Clamp off COOLANT HOSES on independent heater.

Recycling:

Fuel escapes when fuel line is detached. Have a suitable collecting vessel ready.

Catch and dispose of escaping fuel.

Observe country-specific waste disposal regulations.

Necessary preliminary tasks:

Release screws (1).

Remove lower left cover (2).

Fig 1: Identifying Lower Left Cover And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release spring clamps (1) and detach coolant hoses.

Installation note:

Top up coolant and vent COOLING SYSTEM .

Unlock and detach fuel line (2).

Fig 2: Identifying Spring Clamps And Fuel Line

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) and disconnect.

Unfasten screws (2).

Lower independent heater (3).

Installation note:

Make independent heater (3) is correctly seated.

Fig 3: Identifying Plug Connections, Independent Heater And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release spring strap (1) and detach coolant hose (3).

Remove independent heater (3).

Fig 4: Identifying Spring Strap, Coolant Hose And Independent Heater

Courtesy of BMW OF NORTH AMERICA, INC.