51 42 000 Remove and install left or right rear door trim panel

Special tools required:

Necessary preliminary tasks:

Release screws (1).

Installation:

Tightening torque 51 42 1AZ .

Fig 1: Identifying Rear Door Trim Panel Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip clips (1) 00 9 317 of door trim with special tool.

NOTE: Start unclipping at bottom. Damaged clips must be replaced.

Lift door trim panel out of holder.

Fig 2: Identifying Rear Door Trim Panel Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Disengage Bowden cable (1) for release lever first at counter support (2) and then at door lock (3).

Disconnect all plug connections and remove door trim panel.

Fig 3: Identifying Bowden Cable, Counter Support And Door Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

After assembling the door trim panel proceed as follows: