51 21 125 Removing and installing/replacing support for left or right outer door handle with lock barrel

Necessary preliminary tasks:

Close side window (1); in so doing, do not crush or pinch rubber guides (2).

Fig 1: Identifying Pinch Rubber Guides And Window

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) on cap (2).

Remove cap (2).

Installation note:

Rubber seal (3) must sit correctly in guides on door outer skin.

Fig 2: Identifying Cap, Rubber Seal And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release retaining screw (1).

Remove plastic guide underneath.

Installation note:

Correctly insert retaining lug (2) and move to stop.

Fig 3: Removing Plastic Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Turn carrier for door outside handle (1) approx. 90° and feed out below.

Installation note:

Ensure correct Bowden cable installation position.

Fig 4: Turning Door Outside Handle Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Feed Bowden cable (1) out of carrier (2).

If required, modify LOCK BARREL .

Fig 5: Identifying Bowden Cable And Carrier

Courtesy of BMW OF NORTH AMERICA, INC.