51 13 220 Removing and installing / replacing middle trim strip on rear lid

Special tools required:

Necessary preliminary tasks:

Release screws (1) on inside of rear lid.

Unlock and disconnect plug connection (2) - rear lid actuation button and plug connection (3) - reversing camera.

Fig 1: Identifying Rear Lid Actuation Button, Reversing Camera Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Graphic originates from F01

Carefully detach trim strip (1) from rear lid (2) with special tool 00 9 317 and remove

Installation:

If necessary, replace damaged plastic clips (3).

Fig 2: Disconnecting Trim Strip From Rear Lid Using Special Tool (00 9 317)

Courtesy of BMW OF NORTH AMERICA, INC.