51 71 346 Removing and installing/replacing right (rear) suspension cross-brace

IMPORTANT: Driving without the suspension cross-brace is not permitted. (risk of damage to the body).

Release expanding rivets (1) and remove cover (2).

Installation note:

Replace damaged expanding rivets.

Holder of cover (2) must snap into place in suspension cross-brace during installation.

Fig 1: Identifying Suspension Cross-Brace Expanding Rivets, Cover And Holders (51 71 346)

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque 51 61 1AZ .

Remove suspension cross-brace (2).

Installation note:

Make sure suspension cross-brace (2) is in correct installation position.

Replace screw (1).

Fig 2: Identifying Suspension Cross-Brace With Screws (51 71 346)

Courtesy of BMW OF NORTH AMERICA, INC.