64 11 262 Removing and installing/replacing auxiliary water pump (S63)

Special tools required: 

• 17 2 050

Recycling 

Coolant emerges when coolant lines are detached. Have a suitable collecting vessel ready.

Catch and dispose of emerging coolant.

Observe country-specific waste disposal regulations.

Necessary preliminary tasks: 

• Remove FAN COWL FOR ELECTRIC FAN
• DRAIN COOLANT

Unlock plug connections (1) and disconnect.

Unlock and disconnect coolant hose (3) from auxiliary water pump for charge air cooler (2).

Open the hose clamp (5) on the coolant hose (4).

Detach coolant hose (4).

Fig 1: Identifying Charge Air Cooler, Coolant Hose, Clamp And Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (2).

Open the clamp (1) and feed the auxiliary water pump for the charge air cooler (3) out toward the top.

Installation note: 

Make sure auxiliary water pump for the charge air cooler (3) is seated correctly in the auxiliary water pump holder.

Fig 2: Identifying Charge Air Cooler, Clamp And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

For better removal, place the holder (1) with the auxiliary water pump (4) upward.

Unlock spring clamps (3) with special tool 17 2 050 .

Pull off coolant hoses (2) from auxiliary water pump (4).

Release screws (5).

Remove the auxiliary water pump (4) from the bracket (1).

Fig 3: Identifying Coolant Hoses, Auxiliary Water Pump, Spring Clamps

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

Make sure auxiliary water pump (4) is seated correctly in bracket (1).

After installation: 

• FILL COOLING SYSTEM
  IMPORTANT: Filling and bleeding must not be performed in ECO-PRO MODE!
• CHECK COOLING SYSTEM FOR LEAKS