41 63 003 Replacing cover bowl: Notes

Special tools required:

00 9 321

Necessary preliminary tasks:

Remove FLAP FOR FUEL FILLER NECK

NOTE: Carry over schematic representation to the relevant vehicle type.

IMPORTANT: Deformation of the sheet metal flanges in the side panel and the wheel arch results in permanent vehicle leakage. Carry out removal/installation with great care.

Following new body parts are required (refer to BMW Electronic Parts Catalogue):

(1) Filler bowl

Fig 1: Identifying Filler Bowl
Courtesy of BMW OF NORTH AMERICA, INC.

Release rubber collar (1) from cover bowl (2) by pressing inward.

NOTE: Rubber collar (1) remains attached to vehicle.

Fig 2: Identifying Rubber Collar And Cover Bowl

Courtesy of BMW OF NORTH AMERICA, INC.

Press retaining strap (1) inwards and remove.

Remove grommets (2).

NOTE: Grommets (2) are replaced with new cover bowl.

Fig 3: Identifying Retaining Strap And Grommets

Courtesy of BMW OF NORTH AMERICA, INC.

Turn sleeve (1) through approx. 45° and pull out in direction of arrow.

Fig 4: Turning Sleeve To 45 Degrees

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Locks (1) on left/right of cover (2) must not be damaged.

Fig 5: Identifying Left/Right Cover And Locks

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: For purposes of clarity, picture shows cover bowl removed.

Insert screwdriver to specified measurement a and unlock cover bowl catch.

Measurement a = approx. 10 mm

Fig 6: Releasing Cover Bowl Catch Using Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Keep cover bowl tensioned with pliers (1).

Unlock catches individually with screwdriver (2).

Unlock catches in following order:

Top left
Bottom left
Top right
Bottom right

Move screwdriver in opposite direction at both lower catches.

Fig 7: Unlocking Catches Using Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Close hinge arm (1).

IMPORTANT: Do not damage sheet metal flange of side panel.

Carefully twist out cover bowl (2) at first at rear in direction of arrow from side panel and remove.

Fig 8: Twisting Cover Bowl

Courtesy of BMW OF NORTH AMERICA, INC.