51 64 020 Removing and installing/replacing top rear connection: Notes

WARNING: Scalding hazard!
Only perform work after engine has cooled down.

IMPORTANT: Driving without the connection is not permitted. (risk of damage to the body).

Necessary preliminary tasks:

NOTE: Graphic shows the left side only. Apply mirror image of graphic to the right side.

Release screws for air duct (1) on left and right.

Tightening torque 13 71 7AZ .

Release screws on connection at rear (2) left and right.

Fig 1: Identifying Engine Compartment Lid Catch, Air Duct And Rear Left And Right Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Tightening torque 51 61 3AZ .

Release rear screws for engine compartment lid catch (3) on left and right.

Tightening torque 51 61 5AZ .

Release screw (1).

Release screw connection for supports (2).

Tightening torque 51 61 6AZ .

Fig 2: Identifying Screw Connection And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Shown removed here for purposes of clarity.

Raise front/rear connection (1) and disengage Bowden cable (2) in marked area.

Remove front/rear connection (1).

Fig 3: Identifying Front/Rear Connection And Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.