Adjusting pre-tension on windscreen

In order to avoid wind noises, windscreen (1) must be lower than roof outer skin (2).

Position special tool 51 0 010 in middle of vehicle depending on measurement (A) and check underprotrusion of windscreen (1).

A = 4 mm without HUD

A = 3.5 mm with HUD

A = 3 mm with HUD and acoustics

X = measurement stages 1... 4 mm

Fig 1: Adjusting Windscreen Pre-Tension Using Special Tool (51 0 010)

Courtesy of BMW OF NORTH AMERICA, INC.

Version with HUD only:

Check HUD functions again and, if necessary, adjust the head-up display. See GENERAL NOTES ON THE HEAD-UP DISPLAY and ADJUSTING HEAD-UP DISPLAY .

Only with camera-based driver support systems:

Carry out camera calibration via diagnosis system.

Under Service Functions menu: