11 13 Oil sump
TIGHTENING TORQUE SPECIFICATION - OIL SUMP
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Plug Oil drain to oil sump. | N54 | M12 x 1.5 | Replace sealing ring. | 25 Nm |
| 2AZ ASA screw Oil sump (aluminium) to crankcase lower half. Aluminium screws/bolts are permitted with and without color coding (blue). |
N54 | M8 x 26 | Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | |||
| Angle of rotation | 60 ° | |||
| 3AZ ASA screw Oil sump (aluminium) to crankcase lower half. Aluminium screws/bolts are permitted with and without color coding (blue). |
N54 | M8x112/M8x92 | Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | |||
| Angle of rotation | 180 ° | |||
| 4AZ ASA screw Oil sump (aluminium) to crankcase lower half. Aluminium screws/bolts are permitted with and without color coding (blue). |
N54 | M8 x 36 | Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | |||
| Angle of rotation | 90 ° | |||
| 5AZ ASA screw Oil deflector to crankcase lower half. Aluminium screws/bolts are permitted with and without color coding (blue). |
N54 | M6 x 20 | Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | |||
| Angle of rotation | 90 ° | |||
| 6AZ ASA screw Transmission to oil sump. |
N54 | M8 x 50 | 19 Nm | |
| 7AZ Hexagon screw Holder, transmission oil cooler line, to oil sump. |
N54 | M6 x 30 | 8 Nm | |
| 8AZ Hexagon nut Oil level sensor to oil sump. |
N54 | M6 | 8 Nm | |
| 9AZ Transmission fluid cooler bracket to oil sump | N54 | M8 | 9 Nm |