11 41 Oil pump with strainer and motor
TIGHTENING TORQUE SPECIFICATION - OIL PUMP WITH STRAINER AND MOTOR
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Intake pipe to bedplate | N54 | M6x30 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | |||
| Angle of rotation | 100 ° | |||
| 2AZ Oil pump to bedplate | N54 | M8x123 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 10 Nm | |||
| Angle of rotation | 180 ° | |||
| N54 | M8x31 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. |
||
| Jointing torque | 10 Nm | |||
| Angle of rotation | 90 ° | |||
| 3AZ Chain module to crankcase and oil pump | N54 | M6x16 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | |||
| Angle of rotation | 45 ° | |||
| 4AZ Sprocket to oil pump | N54 | M8 | Jointing torque | 20 Nm |
| Angle of rotation | 45 ° |