51 43 070 Removing and installing/replacing side trim panel, footwell, on A-pillar, left

Necessary preliminary work:

Release screw (1).

Release screw (2).

Fig 1: Identifying Trim Panel Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully lever out A-pillar trim panel (2) using special tool 00 9 317 .

Disconnect plug connection behind.

Fig 2: Removing A-Pillar Trim Panel Using Special Tool (00 9 317)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure A-pillar trim panel (3) is correctly seated.

If necessary, replace both clips (1) and clamp (2).

Fig 3: Identifying A-Pillar Trim Panel And Clamps

Courtesy of BMW OF NORTH AMERICA, INC.