51 22 300 Removing and installing/replacing window cavity cover strip on rear door on left or right
IMPORTANT:
To remove weather strip, observe PROCEDURE
for using special tool 00 9 324
.
The "INSTRUCTIONS ON FITTING WINDOW GUIDE SEALS " serve as the basis for this repair instruction and must be observed without fail.
IMPORTANT:
If reusing the existing window cavity cover strip (1), make sure it is not bent.
Tape off area below window cavity cover strip with fabric adhesive tape (2).
Lever out window cavity cover strip (1) with special tool 00 9 324 (starting at B-pillar).
Installation note:
Seal (1) must be correctly fitted in cover strip (2).
Moisten seal (1) prior to fitting with approved lubricant, see 3. AUXILIARY MATERIALS AND TOOLS .