26 11 Propeller Shaft. complete
TIGHTENING TORQUE SPECIFICATION - PROPELLER SHAFT
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Front flexible disc to transmission output flange ZNS screws and nuts All versions |
Replace bolts and nuts Jointing torque and angle of rotation must be observed without fail Tightening via screw |
|||
| F01/F02/F03/F07/F10/F11/F12/F13/F18/F25 | M12-10.9 | Jointing torque | 55 Nm | ||
| Angle of rotation | 90 ° | ||||
| 2AZ | Front flexible disc to propeller shaft ZNS screws and nuts All versions | Replace bolts and nuts Jointing torque and angle of rotation must be observed without fail Tighten via nut |
|||
| F01/F02/F03/F07/F10/F11/F12/F13/F18/F25 | M12-10.9 | Jointing torque | 55 Nm | ||
| Angle of rotation | 90 ° | ||||
| 3AZ | Flexible disc, rear, to transmission drive flange (inserted) ZNS screws and nuts All versions |
Replace bolts and nuts Jointing torque and angle of rotation must be observed without fail Tightening via screw |
|||
| F01/F02/F03/F07/F10/F11/F12/F13/F18 | ASA M12-10.9 | Jointing torque | 55 Nm | ||
| Angle of rotation | 90 ° | ||||
| 4AZ | Flexible disc, rear, to propeller shaft ZNS screws and nuts All versions |
Replace bolts and nuts Jointing torque and angle of rotation must be observed without fail Tighten via nut |
|||
| F01/F02/F03/F07/F10/F11/F12/F13/F18 | M12-10.9 | Jointing torque | 55 Nm | ||
| Angle of rotation | 90 ° | ||||
| 5AZ | Centre mount to body | F01/F02/F03/F07/F10/F11/F12/F13/F18/F25 | 21 Nm | ||
| 6AZ | Drive flange, rear axle final drive (insert nut to propeller shaft/three-hole flange) | F01/F02/F03/F07/F10/F11/F12/F13/F18 | Replace insert nut! Allow min. 2 hours hardening time | ||
| Jointing torque Loosen the insert nut through 90° |
120 Nm | ||||
| Tightening torque | 85 Nm | ||||
| 7AZ | Front propeller shaft to transfer box/front axle differential | F01/F02/F07/F10/F25 | Replace screws Jointing torque and angle of rotation must be observed without fail | ||
| Jointing torque | 20 Nm | ||||
| Angle of rotation | 45 ° | ||||