51 42... Punching contour for seat memory switch into rear door trim panel

Necessary preliminary tasks:

Remove REAR DOOR TRIM PANEL

Position special tool 51 4 107 or 51 4 108 on the recess in the door trim panel storage compartment (1).

Mark cutouts (2).

Fig 1: Positioning Special Tool (51 4 107) Or (51 4 108) On Door Trim Panel Storage Compartment

G06885801

Courtesy of BMW OF NORTH AMERICA, INC.

Use special tool 51 4 109 to punch holes on the previously marked points in the door trim panel (1).

Fig 2: Punching Marked Points In Door Trim Panel Using Special Tool (51 4 109)

G06885802

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: For punching work, special tools 51 4 103 and 51 4 104 must be used as the cutting equipment.

Fig 3: Identifying Special Tools (51 4 104) And (51 4 103)

G06885803

Courtesy of BMW OF NORTH AMERICA, INC.

Slide special tool 51 4 101 through holes stamped into door trim panel (1).

NOTE: Guide pins of punching tool are coded. Distortion is thus not possible.

Fig 4: Sliding Special Tool (51 4 101) Into Door Trim Panel

G06885804

Courtesy of BMW OF NORTH AMERICA, INC.

Mount special tools on punching tool (1).

Compress punching tool (1) via spindle.

Fig 5: Compressing Punching Tool

G06885805

Courtesy of BMW OF NORTH AMERICA, INC.

Press punching remnants from rear out of punching tool using special tool 51 4 111.

NOTE: This work step is necessary to prevent the cutting surfaces from being damaged during a renewed punching operation.

Fig 6: Pressing Punching With Special Tool (51 4 111)

G06885806

Courtesy of BMW OF NORTH AMERICA, INC.