51 12 825 Removing and installing/replacing guide for rear center bumper: Notes

Necessary preliminary tasks:

NOTE: Operation is described on the left side.

The operation on the right side is the same as for the left side.

Release screw (1).

Slacken nut (2).

Tightening torque 51 12 2AZ .

Installation note:

Note line routing.

Fig 1: Identifying Screw And Nut Of Rear Center Bumper

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Tightening torque 51 12 2AZ .

If necessary, remove plug connection on bumper aerial for comfort access system.

Feed out guide (2) and remove.

Fig 2: Identifying Guide And Nut

Courtesy of BMW OF NORTH AMERICA, INC.