51 12 156 Removing and installing/replacing rear bumper trim: Removing

Starting from the outside, carefully snap out the individual guide tabs on left and right
Pull bumper trim (1) straight towards rear with aid of a 2nd person
If necessary, disconnect plug connections
Pull off bumper trim (1)

Fig 1: Identifying Bumper Trim And Mounting Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

PROTECTIVE FILM FOR PREVENTING PAINT ABRASION in the area of the invisible joint (side frame) must not de damaged or missing.

Guide tabs at top and bottom must not be damaged!

Fig 2: Identifying Protective Film Area On Bumper

Courtesy of BMW OF NORTH AMERICA, INC.