51 12 050 Removing and installing/replacing support for rear bumper trim: Notes

Necessary preliminary tasks:

Lever out expander rivet (1) on adapter (2) and cover (3).

NOTE: Cover can vary.

The towing hitch optional equipment is pictured.

Fig 1: Identifying Rivet, Adapter And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip adapter (1) on bumper trim carrier (2) at marked points.

Fig 2: Identifying Adapter And Bumper Trim Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Operation is described on the left side. Right side identical.

Unscrew nuts (1).

Tightening torque 51 12 1AZ .

Slacken nut (2).

Remove carrier for rear bumper trim (3).

Fig 3: Identifying Rear Bumper Trim And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.