51 71 345 Removing and installing/replacing left (rear) suspension crossbrace

IMPORTANT: Driving without the suspension cross-brace is not permitted. (risk of damage to the body).

Release expanding rivets (1) and remove cover (2).

Installation note:

Replace damaged expanding rivets.

Holders (3) must snap into place in suspension cross-brace when cover (2) is installed.

Fig 1: Identifying Expanding Rivets, Cover And Holders

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque, 51 61 1AZ .

Remove suspension cross-brace (2).

Installation note:

Make sure suspension cross-brace (2) is in correct installation position.

Replace screws (1).

Fig 2: Identifying Suspension Cross-Brace And Screws

Courtesy of BMW OF NORTH AMERICA, INC.