51 14 010 Removing and installing/replacing rear BMW badge

IMPORTANT: The INSTRUCTIONS on component cementing with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.

Carefully heat BMW badge (1) with hot air blower and lever out with special tool 00 9 322 .

Fig 1: Removing BMW Badge Using Special Tool (00 9 322)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Pull liner* off adhesive tape (1).

Position badge over guides (2 and 3) and press down firmly.

* Liner is the protective film on a new badge.

Fig 2: Identifying Adhesive Tape And Badge Over Guides

Courtesy of BMW OF NORTH AMERICA, INC.