31 51 015 Replacing shaft seal for left output shaft

Special tools required:

Necessary preliminary work:

Lever shaft seal (1) out of front axle differential (3) with a fork wrench (2).

Fig 1: Identifying Shaft Seal Out Of Front Axle Differential With Fork Wrench

Courtesy of BMW OF NORTH AMERICA, INC.

Install radial shaft seal:

NOTE: The installation protective ring (1) serves to protect the sealing lips of the radial shaft seal (2) when the output shaft is being installed.

Fig 2: Identifying Protective Ring And Radial Shaft Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Drive in shaft seal with special tool 31 5 130 up to limit position.

Fig 3: Installing Shaft Seal With Special Tool (31 5 130)

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: