Preparation of new part

Open welded connections in area (1).

Remove sill section (2).

Fig 1: Identifying Sill Section And Welded Connection Area

Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cut (1) in accordance with vehicle and cut.

Do not grind/sand new part in area of bonding surfaces.

Fig 2: Identifying Severance Cut Mark

Courtesy of BMW OF NORTH AMERICA, INC.

Installing sill section 

Apply K5 ADHESIVE  to bonding surfaces (1).

Install new part and reinforcement plate and weld in place.

Fig 3: Identifying Reinforcement Plate Bonding Surfaces

Courtesy of BMW OF NORTH AMERICA, INC.