Preparation of new part

Adjust new part in conjunction with side panel in front to fit.

In area of bonding surfaces (1), set 2 4.2 mm dia. bore holes (2) for blind rivetsN3.

Remove new part and deburr holes.

Fig 1: Identifying Bonding Surface And Bore Holes

Courtesy of BMW OF NORTH AMERICA, INC.

Fit in new part.

In area of adhesive surface (1), drill a 4.2 mm dia. bore hole (2) for blind rivet N3.

Remove new part and deburr holes.

Fig 1: Identifying Adhesive Surface And Bore Hole

Courtesy of BMW OF NORTH AMERICA, INC.