Removal of the outside wheel arch

Open weld joints in area (1).

Remove reinforcement (2) C-pillar.

Fig 1: Identifying C-Pillar Reinforcement And Weld Joints In Area

Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cut in accordance with specified measurement and cut.

IMPORTANT: Cut outer panel only.

Measurement a = approx. 180 mm.

Open weld joints in areas (1).

Installation note:

Weld in REINFORCEMENT PLATE at severance cut.

Fig 2: Identifying Reinforcement Plate Weld Joints In Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in areas (1).

Open rivet joints in area (2).

Installation note:

Coat new CAVITY SEALS (3) with sealant.

Use Hemlock 813 blind rivet (sourcing reference: BMW Parts Service picture board - Aluminium and steel/bonding and welding).

Fig 3: Identifying Rivet Joints In Area, Weld Joints In Areas And Cavity Seals

Courtesy of BMW OF NORTH AMERICA, INC.

View from inside.

Open spot-weld bonded joints in area (1)

Open welded connections in areas (2).

Remove outer section of wheel arch.

Fig 4: Identifying Spot-Weld Bonded Joints Area And Welded Connection Areas

Courtesy of BMW OF NORTH AMERICA, INC.