Removing the cowl panel

Release screw (1) for airbag.

Tightening torque 72 12 2AZ .

IMPORTANT: Risk of damage!

Airbag (2) must not be kinked or bent!

Fig 1: Identifying Airbag And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Use protective sleeve (1) to protect the airbag.

Check protective sleeve for damage prior to use.

A damaged protective sleeve must not be used!

(2) Velcro fastener
(3) Loop

Fig 2: Identifying Protective Sleeve, Velcro Fastener And Loop
Courtesy of BMW OF NORTH AMERICA, INC.
- Order number, protective sleeve:
  81 47 2 159 578

Slide protective sleeve (1) onto airbag under roofliner so that airbag is completely covered.

Fasten protective sleeve with Velcro fastener (2).

Secure protective sleeve with airbag against kinking.

Fig 3: Identifying Protective Sleeve And Velcro Fastener

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 4: Identifying Roof Edge And Severance Cut Dimensions

Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cuts in accordance with specified dimensions and cut.

IMPORTANT: Cut outer panel only for following severance cuts.
Dimensions a = approx. 150 mm from roof edge.
Dimension b = approx. 400 mm below severance cut a.
Open welded connections in areas (1).
Release part section of cowl panel from cavity sealing (2) and remove it.