51 34... Removing and installing trim on window frame of rear door (rear), left or right

Special tools required:

Do not scratch or damage visible surfaces.

Necessary preliminary tasks:

Feed out rubber window seal (1) in vicinity of cover.

Installation note:

Follow instructions for fitting rubber window seals.

Fig 1: Removing Rubber Window Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew screws (2) from cover (1).

Tightening torque 51 35 5AZ .

Fig 2: Identifying Window Frame Screws And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Lift frame trim from window frame (1) a little way using a special tool 00 9 325 and move cover (2) downwards.

Installation note:

Engage frame trim correctly into retaining clips at window frame (1) if necessary.

Fig 3: Lifting Frame Trim From Window Frame Using Special Tool (00 9 325)

Courtesy of BMW OF NORTH AMERICA, INC.

Mask off frame trim at window frame with adhesive tape (2).

Carefully tilt cover (1) outwards, pull out upwards and lay it down.

Fig 4: Pulling Window Frame Cover

Courtesy of BMW OF NORTH AMERICA, INC.