12 61 280 Removing and installing/replacing oil pressure sensor (N52T)

WARNING: Risk of burning!
Only perform this task on an engine that has cooled down.

Necessary preliminary work:

Installation location:

Oil filter housing, front left.

Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.

Unlock plug (1) and remove.

Release oil pressure sensor (2).

Tightening torque 12 61 2AZ .

Installation note:

Check engine oil level, top up engine oil if necessary.

Fig 1: Identifying Oil Pressure Sensor And Plug

Courtesy of BMW OF NORTH AMERICA, INC.