24 35 510 Replacing Wiring Harness In Automatic Transmission (GA8P70H) N55_Hybrid

Special tools required:

24 1 430
24 2 390

IMPORTANT:

Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
Wear protective gloves.
Ensure adequate ventilation.

NOTE: After completing repair work:

Load specific data version with ISTA.

IMPORTANT: After completion of repair work, CHECK TRANSMISSION OIL LEVEL .
Use only approved transmission oil .
Failure to comply with this requirement will result in serious damage to the automatic transmission!

IMPORTANT: Read and comply with notes on PROTECTION AGAINST DAMAGE FROM ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary work:

Remove MECHATRONICS .

Release screws (1).

Pull connector (2) out of housing.

Pull cable connections (3) out of housing.

Tightening torque: 24 30 2AZ .

Fig 1: Transmission Connector, Cable Connection And Screw

Courtesy of BMW OF NORTH AMERICA, INC.