24 13 015 Replace Radial Shaft Seal For Output Flange (GA8HP45Z)
Special tools required:
- Do not let skin come in contact with transmission oil and do not inhale fuel vapors.
- Wear protective gloves.
- Ensure adequate ventilation.
Use only the approved transmission oil .
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Necessary preliminary tasks:
- Remove complete exhaust system . See 18 00 020 REMOVING AND INSTALLING COMPLETE EXHAUST SYSTEM (N55) , 18 00 020 REMOVING AND INSTALLING COMPLETE EXHAUST SYSTEM (N52T) or 18 00 020 REMOVING AND INSTALLING COMPLETE EXHAUST SYSTEM (N20) .
- Remove transmission cross member.
- Remove propeller shaft . See 26 11 000 REMOVING AND INSTALLING COMPLETE PROPELLER SHAFT (INSERTED - FLEXIBLE DISC AT REAR) .
- Support transmission with lifter.
Release transmission support block from transmission.
Tightening torque: 22 32 1AZ .
Grip output flange (1) with special tool 23 0 020 .
Release nut with special tool 24 2 380 .
Tightening torque: 24 13 1AZ .
Installation note:
Renew inner radial shaft seal.
Renew output flange.
Replace nut and secure with a mandrel (8 mm) by caulking.
Detach output flange from output shaft.
Remove spacer.
Attach special tool 24 2 353 to output shaft (1).
Screw in special tool 24 2 351 until it is firmly connected with radial shaft seal.
Pull out radial shaft seal by screwing in special tool 24 2 352 .
Oil sealing lip on radial shaft seal (1).
Drive in radial shaft seal (1) with special tool 24 2 370 and adapter ring 24 2 410 as far as it will go.