18 00 020 Removing and installing complete exhaust system (S63 B44 T 0)

Special tools required:

WARNING: Risk of burning!
Only perform this repair work after engine has cooled down.

Danger of injury!

Removal of the exhaust system must be carried out with the assistance of a second person.

Necessary preliminary tasks:

Support exhaust system with jack and special tool 31 2 220 or with a suitable lever and secure against falling down.

Fig 1: Supporting Exhaust System Using Special Tool (31 2 220)

Courtesy of BMW OF NORTH AMERICA, INC.

Picture shows the left side, the procedure for the right side is identical.

Unscrew nuts (1).

Replace self-locking nuts.

Tightening torque 18 31 1AZ .

Fig 2: Identifying Exhaust System Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Tightening torque 18 20 1AZ .

Fig 3: Identifying Exhaust System Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts (1).

Tightening torque 18 20 3AZ .

Unfasten screws (2).

Tightening torque 51 61 17AZ .

Release screws (3).

Tightening torque 18 20 6AZ .

Feed out and remove reinforcement plate (4).

Fig 4: Identifying Reinforcement Plate, Nuts And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Picture shows the left side, the procedure for the right side is identical.

Unscrew nuts (1).

Tightening torque 18 20 4AZ .

Remove earth strap.

Fig 5: Identifying Earth Strap Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Picture shows the left side, the procedure for the right side is identical.

Detach hose (1) on vacuum unit.

Slacken nut (2).

Tightening torque 18 20 5AZ .

Lower and remove exhaust system with assistance of a second person.

Fig 6: Identifying Vacuum Unit Hose And Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Check rubber mount for damage.

If necessary, replace damaged rubber mounts.

Check exhaust system for leak tightness.