64 11 377 Removing and installing/replacing heater/air conditioner operator unit (version without CCC/ASK)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 335is, 2013 BMW 335i, 2012 BMW 335is, 2012 BMW 335i, and 2011 BMW 335is. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 340

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) !

NOTE: C ar C ommunication C omputer (CCC) A udio S ystem K ontroller/Controller (ASK)

Lever out heater/air conditioner operator unit (1) with special tool 00 9 340 and pull.

Disconnect associated plug connections.

Remove heater/air conditioner operator unit (1) complete with center console switch cluster (2) and trim (3).

Fig 1: Removing Heater/Air Conditioner Operator Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement

Carefully unclip operator unit trim (1) at inner retaining points (2) only.

IMPORTANT: Risk of damage to operator unit (3)!

Fig 2: Identifying Operator Unit Trim And Inner Retaining Points

Courtesy of BMW OF NORTH AMERICA, INC.

Carefully unclip operator unit trim (1) at outer retaining points (2) only.

Remove trim (1) from operator unit (3).

Fig 3: Identifying Operator Unit Trim And Outer Retaining Points

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement

Carry out PROGRAMMING/CODING .