51 45... Removing And Installing Carrier For Instrument Panel
Necessary preliminary tasks
- Remove INSTRUMENT PANEL TRIM
- Disconnect all necessary cable ties on support tube
- Release wiring harnesses/cable ducts and lay to one side
- If necessary, remove control units/disconnect plug connections
WARNING:
To avoid injury, cover holder (1) on support tube (2).
Detach wiring harness (3) from support tube (2).
Release screws (1) of heater on support tube (2).
Tightening torque 64 11 6AZ .
Release nuts (1) on right and left on support tube (2).
Tightening torque 51 71 5AZ .
Release screw (1) of heater on support tube (2).
Tightening torque 51 71 6AZ .
Release screw (1) on support tube (2).
Tightening torque 51 71 5AZ .
Release screws (1) on support tube (2) from bracket (3).
Tightening torque 51 71 4AZ .
Detach support tube (2) with a 2nd person helping and remove.