51 14 000 Removing And Installing/Replacing Front BMW Badge

Special tools required: 

• 00 9 325

To avoid damaging the paintwork on the engine hood/bonnet, tape off edge areas (1) to sides of guide pins.

So as not to subject the BMW badge to excessive deformation, lever out the badge with special tool 00 9 325 at guide pins (2).

Fig 1: Removing Badge With Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

The following parts must not be damaged or missing, replace if necessary:

1. Badge
2. Guide pins
3. Grommets

Adhesive tape (4)

Fig 2: Badge, Guide Pins, Grommets, Adhesive Tape

Courtesy of BMW OF NORTH AMERICA, INC.