Handlebars and struts
TIGHTENING TORQUE SPECIFICATIONS - HANDLEBARS AND STRUTS
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Trailing arm to rear axle support | E81/E82/E84/E87/E88/E90/E91/E92/E93 | M12 | Replace nut. TIGHTEN DOWN BOLT CONNECTION IN NORMAL POSITION . |
100 Nm |
| 2AZ | Trailing arm to wheel carrier | E81/E82/E84/E87/E88/E90/E91/E92/E93 | M12 | Replace nut. TIGHTEN DOWN BOLT CONNECTION IN NORMAL POSITION . |
100 Nm |
| 3AZ | Control arm to rear axle support | E81/E82/E84/E87/E88/E90/E91/E92/E93 | M12 | Replace nut. TIGHTEN DOWN IN NORMAL POSITION . |
100 Nm |
| 4AZ | Control arm to wheel carrier | E81/E82/E84/E87/E88/E90/E91/E92/E93 | M12 | Replace screw. TIGHTEN DOWN IN NORMAL POSITION . |
|
| Jointing torque | 100 Nm | ||||
| Angle of rotation | 90 ° | ||||
| 5AZ | Wishbone to rear axle support | E81/E82/E84/E87/E88/E90/E91/E92/E93, | M12 | Replace nut. TIGHTEN DOWN IN NORMAL POSITION . |
100 Nm |
| 6AZ | Wishbone to wheel carrier | E81/E82/E84/E87/E88/E90/E91/E92/E93 | M12 | Replace screw and nut. TIGHTEN DOWN IN NORMAL POSITION . |
|
| Jointing torque | 100 Nm | ||||
| Angle of rotation | 90 ° | ||||
| 7AZ | Toe arm to rear axle support | E81/E82/E84/E87/E88/E90/E91/E92/E93 | M12 | Replace nut. TIGHTEN DOWN IN NORMAL POSITION . |
100 Nm |
| 8AZ | Toe arm to wheel carrier | E81/E82/E84/E87/E88/E90/E91/E92/E93 | M12 | TIGHTEN DOWN IN NORMAL POSITION . | 100 Nm |
| 9AZ | Camber arm to rear axle support | E81/E82/E84/E87/E88/E90/E91/E92/E93 | M14 | Replace nut. TIGHTEN DOWN IN NORMAL POSITION . |
165 Nm |
| 10AZ | Camber arm to wheel carrier | E81/E82/E84/E87/E88/E90/E91/E92/E93 | M14 | Replace nut. TIGHTEN DOWN IN NORMAL POSITION . |
165 Nm |
| 11AZ | Trailing link to body | E81/E82/E84/E92/auser S65 | M8 | 24 Nm | |
| 12AZ | Trailing link to compression strut | E81/E84/E82/E92/auser S65 | M12 | Replace screw. Jointing torque |
100 Nm |
| Angle of rotation | 90 ° | ||||