1141 Oil pump with strainer and motor (N54)
TIGHTENING TORQUE SPECIFICATIONS - OIL PUMP WITH STRAINER AND MOTOR
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Intake pipe to bedplate | N54/N54T | M6x30 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | ||||
| Angle of rotation | 100 ° | ||||
| 2AZ | Oil pump to bedplate | N54/N54T | M8x123 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 10 Nm | ||||
| Angle of rotation | 180 ° | ||||
| N54/N54T | M8x31 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. |
|||
| Jointing torque | 10 Nm | ||||
| Angle of rotation | 90 ° | ||||
| 3AZ | Chain module to crankcase and oil pump | N54/N54T | M6x16 | Replace screws Thread repairs exclusively with Al Helicoil. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | ||||
| Angle of rotation | 45 ° | ||||
| 4AZ | Sprocket to oil pump | N54/N54T | M8 | Jointing torque | 20 Nm |
| Angle of rotation | 45 ° | ||||