1131 Camshaft (N55)
TIGHTENING TORQUE SPECIFICATIONS - CAMSHAFT
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Upper and lower bearing strip of camshaft (steel screw 10.9) | N55 | M7x70 | Insert screws dry | |
| Jointing torque | 8 Nm | ||||
| Angle of rotation | 60 ° | ||||
| 2AZ | Eccentric shaft bearing cap to cylinder head | N55 | M6x27 | 8.5 Nm | |
| 3AZ | Camshaft bearing cap to cylinder head | N55 | M6x30.5 | 8.5 Nm | |
| 4AZ | Chain drive module to cylinder head | N55 | M6x35 | 8 Nm | |
| 5AZ | Guide rail to crankcase | N55 | M8 | 20 Nm | |
| 6AZ | Guide rail to cylinder head | N55 | M7 | 14 Nm | |
| 7AZ | Chain tensioner to cylinder head | N55 | M22 x 1.5 | Do not retighten the chain tensioner. Replace sealing ring, thread lightly oiled |
55 Nm |
| 8AZ | Screw plug in cylinder head | N55 | M18x1.5 | 25 Nm | |