1113 Oil sump (N55)
TIGHTENING TORQUE SPECIFICATIONS - OIL SUMP
| Type | Thread | Tightening specifications | Dimension | ||
|---|---|---|---|---|---|
| 1AZ | Oil drain plug to oil sump | N55 | M12x1.5 | Replace sealing ring. | 25 Nm |
| 2AZ | Oil sump (aluminum) to crankcase lower half. | N55 | M8x26 | Replace screw. Thread repairs exclusively with aluminum Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | ||||
| Angle of rotation | 90 ° | ||||
| 3AZ | Oil sump (aluminum) to crankcase lower half. | N55 | M8x92 M8x112 | Replace screw. Thread repairs exclusively with aluminum Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | ||||
| Angle of rotation | 180 ° | ||||
| 4AZ | Oil sump (aluminum) to crankcase lower half (AWD) | N55 | M8x36 | Replace screw. Thread repairs exclusively with aluminum Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 8 Nm | ||||
| Angle of rotation | 90 ° | ||||
| 5AZ | Oil deflector to crankcase lower half. | N55 | M6x20 | Replace screw. Thread repairs exclusively with aluminum Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | ||||
| Angle of rotation | 90 ° | ||||
| 6AZ | Transmission to oil sump. | N55 | M8x50 8.8 | 19 Nm | |
| 7AZ | Oil level sensor to oil sump. | N55 | M6 | 8 Nm | |