54 37... Removing butyl

Special tools required:

Method A

Press out excess butyl with fishbone 00 9 321 under seal (1).

Fig 1: Pressing Out Excess Butyl With Fishbone 00 9 321 Under Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Stick adhesive strip (1) onto butyl and press down gently with fishbone 00 9 321 .

IMPORTANT: Risk of paintwork damage!

Fig 2: Pressing Down Gently With Fishbone 00 9 321

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off adhesive strip (1).

If necessary, repeat procedure with new adhesive strip until butyl is removed.

Fig 3: Removing Adhesive Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Method B

NOTE: Procedure in event of large-scale fouling of vehicle surface by butyl:

Shape lumps out of butyl remnants.

Press down butyl lumps (1) and pull off.

Repeat procedure until butyl remnants have been removed.

Clean painted surfaces with adhesive remover.

Fig 4: Pressing Down Butyl Lumps

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Adhesive remover attacks paint surfaces if allowed to act on surface for an extended period of time!