54 37... Convertible top assembly position

Move convertible top so that angle of hinges is greater than 90°.

Fig 1: Moving Convertible Top Angle Of Hinges Greater Than 90°

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage! Pressure in hydraulic system drops and convertible top loses its position.

Support rear roof shell to convertible top cover with suitable auxiliary material, e.g. hard foam.

Rear roof shell is supported by auxiliary material on convertible top cover.

Auxiliary material must lie over wide area and over entire length.

Fig 2: Supporting Rear Roof Shell To Convertible Top Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Select auxiliary material with a smooth surface, as otherwise pressure points in the outer skin and seal may arise.

Roof shells block each other.