25 11 071 Replacing knob for shift lever

WARNING: As from 03/07 there are two different versions. Version 2 can give rise to damage if incorrectly removed.

Version 1: Shift lever knob and shift lever cover separate .

Version 2: Shift lever knob and shift lever cover are a single part .

Version 1 (shift lever knob and shift lever cover separate):

Press installation frame of gaiter (1) together a little and remove gaiter from center console.

IMPORTANT: Start removing at front left, otherwise the frame may be damaged.

Fig 1: Pressing Gaiter Frame

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Do not twist shift lever knob during removal as this would cause the turning lock in the knob to shear off.

Tug firmly to remove knob.

Installation

Fit shift lever knob on shift lever, align and press on until it snaps noticeably into place.

Fig 2: Installing Shift Lever Knob On Shift Lever

Courtesy of BMW OF NORTH AMERICA, INC.

Installation

Push gaiter (1) down until groove (2) is fully exposed.

Fig 3: Pushing Gaiter Down

Courtesy of BMW OF NORTH AMERICA, INC.

Version 2 (shift lever knob and shift lever one single part):

Press installation frame of gaiter (1) together a little and remove gaiter from center console.

IMPORTANT: Start removing at front left, otherwise the frame may be damaged.

Fig 4: Pressing Gaiter Frame

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Do not twist knob during removal as this would cause the turning lock in the knob to shear off.

Tug firmly to remove knob.

Installation

Fit knob on shift lever, align and press on until it snaps noticeably into place.

Fig 5: Installing Shift Lever Knob On Shift Lever

Courtesy of BMW OF NORTH AMERICA, INC.