51 71 482 Removing and installing/replacing left or right trailing link (on rear axle) (from 03/2007)

IMPORTANT: Observe SAFETY INFORMATION for raising the vehicle
Driving without the trailing link is not permitted!

Left tension strut

Release bolts (1, 3, 4, 5) and remove left trailing link (2).

Installation note:

Make sure screws are installed in correct positions.

Fig 1: Identifying Trailing Link Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Right tension strut

NOTE: Remove left trailing link.

Release screws (1, 3) and remove right trailing link (2).

Installation note:

Make sure screws are installed in correct positions.

Screw (1) M12x35
Tightening torque 51 71 21AZ .
Screw (3) M10x25
Tightening torque 51 71 20AZ .

Fig 2: Identifying Trailing Link Screws
Courtesy of BMW OF NORTH AMERICA, INC.