32 11 100 Replacing gaiter for steering box on left or right

IMPORTANT: The hydraulic steering gear must be replaced if the polished surface of the rack is damaged (e.g. by corrosion)!

Necessary preliminary tasks:

Remove UNDERBODY PROTECTION
Remove COVER of front steering assemblies (diesel-engine cars with rear-wheel drive only)
Remove TRACK ROD END

Clean track rod.

Release band clamp (1), EAR CLAMP (1) and band clamp (2).

Detach gaiter from track rod.

Installation note:

Clean rack and check surface for damage (e.g. by corrosion).

Clean track rod and apply grease to taper.

Fig 1: Identifying Band And Ear Clamp

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: This ensures that the gaiter is not rotated when the track rod is rotated.

After installation: