31 12 050 Removing and installing/replacing left or right trailing link

Necessary preliminary tasks:

Release screws (1).

Remove cover (2).

Fig 1: Identifying Temperature Sensor Cover And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1), if necessary, grip at inner Torx socket.

Tightening torque: 31 12 2AZ .

Installation note:

Replace self-locking nut.

Keep trailing link to swivel bearing connection clean and free from oil and grease.

Fig 2: Identifying Slacken Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1).

Tightening torque: 31 12 1AZ .

Remove tension strut.

Installation note:

Replace screw (1).

Tighten down screw connection in NORMAL POSITION .

Fig 3: Identifying Screw

Courtesy of BMW OF NORTH AMERICA, INC.